Motor Assembly - Craftsman professional 152.217050 Manual De Instrucciones

Fig. 4-4 MOTOR ASSEMBLY
N
P
DO NOT assemMe the Jointer/Haner until you are sure
the power switch is in the "OFF" position and the power
cord is disconnected from the power source,
A
6, Lay the stand assemMy onto its Ueftside paneU
assemMy (A) See Figure 4-4,
7, Hace dust chute (M) in between flanges (N) of the
top pUate, See Figures 4-3 and 4-4, Use four
M6 x 12mm hex head screws, M6 fiat washers
and M6 hex nuts to secure dust chute to top pUate,
Do not compUeteUy tighten hardware,
8, Secure bottom of dust chute (0) to Ueftside paneU
with two M6 x 12mm hex head screws, M6 fiat
washers and M6 hex nuts, See Figure 4-4,
9, Tighten aft six screws securing dust chute to stand,
Fig. 4-5 p
1,
Assemble the motor pulley (A) onto the motor shaft
(B), Make sure the two set screws (C) in the motor
pulley are backed off so that the motor pulley can
slide onto the motor shaft, See Figure 5-1,
2,
AHgn the 5mm x 5mm x 30mm square key aUready
in the motor shaft with the keyway in the pufley,
SHde the motor pufley onto the motor shaft until the
pufley is flush with the end of the motor shaft as
shown in Figure 5-1, Tighten both set screws (C) at
this time,
Fig. 5-2 C D
X\
H
10, Thread the four leveling feet with hex nuts (P) to
the tapped holes (Q) in the side panel assemblies,
See Figure 4-5,
3,
4,
5,
12
E
Place the motor assembly (D) onto the dust chute
(E), Make sure the motor pulley (C) is positioned
on the same side as the belt opening (F) in the top
plate, See Figure 5-2,
Secure the motor assembly to the dust chute with
four 5/16-18 x 1-1/8" carriage head screws (G),
MIO flat washers (H) and 5/16-18 hex nuts (I),
Do not completely tighten hardware,
Position the stand assembly upright and adjust
leveling feet so that the stand sits flat to the floor,