THERMAL°OVERLOAD
PROTECTION
CAUTION: 1/2" DEPTH-OF-CUT
iS ONLY USED
iN RABBET-CUTTING
OPERATIONS.
Turn the power switch OFF and unplug the power
cord from its power source prior to performing any
maintenance or adjustments,
Make certain that the OFF button has been depressed
before pushing the thermal-overload-reset
button,
The motor supplied with your Jointer/Planer
has a
resettable thermal=overload relay (F), see figure 13-1,
if the motor shuts off during an operation (cutting a
workpiece too fast or using a dull blades, using the
jointer beyond its capacity, or low voltage) press the
OFF paddle (C) let the motor cool three to five minutes,
Push the reset thermal-overload
button on the side of
the ON/OFF switch, Make certain that the work area
has been cleared of debris before restarting motor, The
motor can now be turned on again by pressing the ON
button (B),
INFEED
TABLE OPERATION
Turn the power switch OFF and unplug the power cord
from its power source prior to performing any mainte=
nance or adjustments,
1.
To raise or lower the infeed table, loosen the infeed
table lock handle (A), To loosen handle, turn
counterclockwise;
to tighten, turn handle clockwise,
See Figure 14-1,
Fig. 14-1
3,
4,
After the depth-of-cut is set, tighten the infeed table
lock handle (A), See Figure 14=1,
The pointer (C) on the depth-of-cut scab (D)
indicates the infeed table depth-of-cut,
See
Figure 14=1,
OUTFEED
TABLE
OPERATION
Turn the power switch OFF and unplug the power cord
from its power source prior to performing any mainte-
nance or adjustments,
CAUTION: The knife edges are sharp, Do not touch,
1,
in order to perform accurate jointing/planing
opera-
tions, the outfeed table (A) must be exactly level
with the highpoint (B) of the knives (C), See
Figure 15=1,
Fig. 15-1
7
A
B
E
//
D
C
2,
Grip the infeed table raise/lower handle, located
under the infeed table and raise or lower handle,
NOTE: For rabbet-cutting operations, the maximum
depth=of=cut pin (B) must be disengaged at 1/8"
depth-of-cut, To disengage, pull knob back toward
you, This will allow the infeed table to lower down
to a maximum of 1/2" depth=of=cut,
3,
19
To adjust the outfeed table (F), loosen lock=thumb
screw (G) on the backside of the outfeed table,
See Figure 15-2,