Starting And Stopping - Craftsman professional 152.217050 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CAUTION
• Aseparate eUectdcaU
circuit s houUd be usedforyour
Jointer/Haner. TheJointer/Haner comespre-wired f or
120-voUt use.Thecircuit s houUd notbe Uess than#14
AWG wireandshouUd be protected w itha 15-amp
timeUag f use.
Havea quaUified eUectdcian repair or repUace dam-
agedor worncordimmediateUy.
Before connecting t hemotor to thepower Hne, m ake
certain theswitchis in the"OFF" position andbesure
thattheeUectric current i s ofthesamecharacteristics
asthe motor namepUate.
AH Hne connections shouUd
makegoodcontact.
Running on Uow voUtage or Uong e xtension c ordswHU
damage themotor.
STARTING
AND STOPPING
2.
To turn the Jointer/Haner
on, press the green "ON"
button (B) in one-half inch. Note: There is a safety
feature on the switch to insure that the switch must
be completely pressed before the motor will start.
3.
To turn the Jointer/Haner
off, press the large red
"OFF" paddle (C) or lift the paddle and press direct°
ly on the red "OFF" button (D). See Figure 13-1
and 13-2.
LOCKING
SWITCH
IN THE "OFF"
PosmoN
CHILDPROOF
THE WORKSHOP
AREA by removing
switch keys, unplugging tools from the electrical recep-
tacles, and using padlocks.
Fig. 13-2
,, DO NOT expose the Jointer/Haner
to rain or operate
it in damp locations,
MAKE SURE all parts have been assembled correctly
and are in working order,
,, KEEP table surfaces clear of tools and debris before
starting,
Fig. 13-1
A
B
r
C
1.
The ON/OFF switch (A) is located on the post over
the infeed table. See Figure 13-1.
E
C
D
1.
When the Jointer/Planer
is not in use, the "ON"
button (B) should be locked so that it cannot be
started. See Figure 13o2.
2.
Using the padlock (E) included with your Jointeri
Planer, lift the red "OFF" paddle (C) and place the
padlock through the holes in the side of the "ON"
button and then lock the padlock. Make sure keys
have been removed from padlock and placed
where no children can get them.
3.
To use the Jointer/Planer, unlock and remove the
padlock from the "ON" button.
18

Publicidad

Tabla de contenido
loading

Tabla de contenido