Craftsman professional 152.217050 Manual De Instrucciones página 13

Fig. 5-3
L
K
1,
2,
Position the Jointer/Haner (A) onto the stand (B) so
that the three studs under the jointer's base a(ign
with the three sbts in the top plate of the stand,
See Figure 6-1,
Secure the jointer to the stand with three MIO fiat
washers, MIO bck washers and MIO hex nuts,
Note: Two of the studs in the jointer base can be
accessed inside of the stand, The third stud can
only be accessed through the dust chute opening in
the side panel Securely tighten aU hardware,
(NFEED TABLE HANDLE ASSEMBLY
6, Start two #10-24 x 3/8" round head flange screws
(J) into the right side panel Only screw them in haft
way,
7, SHde sbts (K) of the push Mock holder (L) down
onto the two screws (J) in the side panel
8, Attach the arm (M) of the push Mock holder to the
hob (N) in the side pane( with one 10-24 x 3/8"
round head flange screw,
9, Securely tighten a)( stand hardware except for
motor mounting hardware at this time.
JO(NTER/PLANER ASSEMBLY
DO NOT assemble the Jointer/Haner until you are sure
the power switch is in the "OFF" position and the power
cord is disconnected from the power source,
CAUTION: Two or more people are required to lift the
Jointer/Haner,
Fig. 6-1
A
Fig. 7-1
@
C B ÷
©
1,
2,
Assemble infeed table handle (A) with hex nut (B)
into threaded block (C) underneath the infeed table,
See Figure 7-1,
When infeed table handle is completely turned into
threaded block, tighten hex (B) nut against block (C),
13