45 Degree
Out Positive
Stop Adjustment
Fig. 17-2
A
F
2,
3,
4,
5,
6,
7,
To set fence 45 degree out to the tame surface, first
make sure the 90 degree stop knob (A) is pulled
out. See Figure 17-2.
Loosen the beveU bck handb (D) and tilt the fence
back and against the 45 degree out positive stop
screw (F).
Tighten beveU bck handb (D), and check that the
fence is 45 degrees to the tame surface with an
accurate square.
if any adjustments
are needed, bosen tilt bck
handb.
Loosen stop nut (G) shown in Figure 17-1 and
adjust 45 degree positive stop screw (F),
Retighten bevel lock handle, and recheck that the
fence is 45 degrees to the table surface.
Repeat steps above until fence is set correctly and
then tighten stop nut,
45 Degree
in Positive
Stop Adjustment
Fig. 17-3
H
1.
To set fence 45 degree in to the table surface, first
make sure the 90 degree stop knob (A) is pulled
out. See Figure 17o3.
2.
Loosen the bevel lock handle (D) and tilt the fence
forward and against the 45 degree in positive stop
screw (H). Note: This positive stop screw does not
touch the fence on the head side of the screw, but
on the threaded end.
3,
Tighten bevel lock handle (D), and check that the
fence is 45 degrees to the table surface with an
accurate square.
if any adjustments are needed, loosen tilt lock
handle.
4,
5.
Loosen stop nut (I) and adjust 45 degree positive
stop screw (H).
6.
Retighten bevel lock handle, and recheck that the
fence is 45 degrees to the table surface.
7.
Repeat steps above until fence is set correctly and
then tighten stop nut.
21