Cleaning And Disinfecting; Storage, Disposal And Recycling - Permobil ROHO AGILITY Operación Manual

Cleaning and Disinfecting

Warnings:
- Cleaning and disinfecting are separate processes. Cleaning must precede disinfection.
Before use by a different individual: clean, disinfect, and check product for proper functioning.
- If instructed to use bleach, follow the safety guidelines on the bleach container.
Cautions:
- DO NOT use abrasives such as steel wool or scouring pads on components of an AGILITY.
- DO NOT use cleaning products containing petroleum or organic solvents [i.e. acetone, toluene, Methyl Ethyl Ketone (MEK), naphtha, dry cleaning fluids,
adhesive removers] on components of an AGILITY.
Back shell:
To Clean: Hand wash in warm (40°C) water with soap and a sponge. Rinse with clean water. Wipe dry with a clean cloth and then
allow to air dry completely.
To Disinfect: Wipe gently with a cloth dampened with a household disinfectant. Rinse with clean water. Wipe dry with a clean cloth
and then allow to air dry completely.
Cover:
Notes: Before cleaning and disinfecting, remove the foam and air components from the cover. Secure the hook and loop fastener strip on the
handle at the wide end of the cover. Turn the cover inside out. Zip the cover closed to avoid snags.
To Clean: Machine wash in warm (40°C) water with mild detergent. Tumble dry low.
To Disinfect: Hand wash in warm (40°C) water using 1 part household liquid bleach per 9 parts water.
Rinse thoroughly with clean water. Or machine wash in hot (60°C) water. Tumble dry low.
Foam pad, foam insert, and lumbar support pad:
To Clean: Wipe lightly with a damp cloth. DO NOT use soap. DO NOT submerge in water. Wipe off with a clean cloth. Completely air
dry before replacing in cover.
To Disinfect: Note: Disinfectants are NOT effective on porous surfaces such as foam. Replace soiled or contaminated foam
components with authorized ROHO foam components only. Replacement foam components may be purchased separately. Soiled or
contaminated foam components MUST NOT be used by different individuals.
:
Air insert
Notes: Remove the air insert from the cover and foam pad prior to cleaning and disinfecting. Make sure the inflation valve is closed. DO
NOT allow water or cleaning solution to enter the air insert.
To Clean: Place in large sink or basin with warm (40°C) water. Hand wash, using mild liquid
hand soap, hand dishwashing liquid, laundry detergent, or a multipurpose detergent (Follow
product label instructions.) Gently scrub all cushion surfaces, using a soft, plastic bristle brush,
a sponge, or a cloth. Rinse with clean water. Air dry. DO NOT machine wash or dry. DO NOT
expose to direct sunlight.
To Disinfect: Hand wash in warm (40°C) water using 1 part household liquid bleach per 9
parts water. Rinse thoroughly with clean water. Air dry. DO NOT machine wash or dry. DO NOT
autoclave.

Storage, Disposal and Recycling

Storage: Clean and disinfect the product before storing. Store the product in a container that protects the product from moisture, contaminants and
damage.
Disposal: The components of the products in this manual are associated with no known environmental hazards when properly used and when disposed of
in accordance with all local/regional regulations. Incineration must be performed by a qualified, licensed waste management facility.
Recycling: Contact a local recycling agency to determine recycling options for the product. For more recycling information, contact ROHO, Inc.
ROHO AGILITY Back System Operation Manual
Note: Remove the foam components from the cover prior to cleaning.
+
10
= Wipe with damp cloth
or
+
1:9
1:9