Cover Components Installation - Permobil ROHO AGILITY Operación Manual

Cover Components Installation

Warning: The air insert and the foam insert are not intended to be used together.
To Install the Foam Pad
(for foam-only models)
1)
Unzip the cover and place the foam pad into the cover. Note: The wide and narrow ends of the foam pad should be aligned with the wide and
narrow ends of the cover.
2)
Zip the cover closed.
3)
Install the cover on the back shell.
To Install the Foam Pad with the Air Insert
1) Slide the valve hose through the hole in the foam pad. The air
cells should face out.
Foam Pad
Air Insert
Cutout
Area
Fastener
Strip
Valve Hose
3)
Unzip the cover. Place the foam pad and air insert into the
cover. The air insert should face the front of the cover. The wide
and narrow ends of the foam pad should be aligned with the
wide and narrow ends of the cover.
To Install the Foam Pad with the Foam Insert
1)
Align the foam insert with the cutout area. Press to secure the fastener strips.
2)
Unzip the cover and place the foam pad with the foam insert attached into the cover.
Note: The side of the foam pad with the foam insert should face the front of the cover. The wide
and narrow ends of the foam pad should be aligned with the wide and narrow ends of the cover.
3)
Zip the cover closed.
4)
Install the cover on the back shell.
ROHO AGILITY Back System Operation Manual
2) Tuck the edges of the air insert under all of the edges of the cutout
area. Press to secure the air insert to the fastener strip in the cutout
area.
4)
a. If adjustment of the air insert is not needed: Place the valve hose
inside the zipper area. Zip the cover closed. Install the cover on the
back shell.
4)
b. If adjustment of the air insert is needed: Partially zip the cover
closed allowing access to the inflation valve. Install the cover on the
back shell. See T A
o djusT The
6
A i .
ir nserT
4a
4b
Cutout Area
Foam Insert