Identifying Setting Steps Already Completed; Pre-Programming The Somfy Io Local Control Point; Checking The Direction Rotation Of The Motor - SOMFY Sunilus io Guia De Instalacion

Sunilus io / Sunilus screen io
5. COMMISSIONING
This guide describe only the comisioning using a Somfy io local control point as Situo io. For comi-
sioning using other io control point, refer to the corresponding guide.

5.1. Identifying setting steps already completed

Only one motor can be powered at a time.
Switch the power on and follow process a or b depending on
the awning reaction:
The awning makes a brief movement.
a
The end limits have been set and no Somfy io
control point has been programmed. Go to chapter
"Programming the first Somfy io local control point".
or
The awning does not move.
b
Press the Up or Down button and follow process c or d
depending on the awning reaction:
The awning still does not move
c
The end limits have not been set and no Somfy io
control point has been programmed.
Go to chapter "Pre-programming the Somfy io local
control point".
or
d The awning goes fully up or fully down
The end limits have been set and the Somfy io
control point has been programmed.
Go to chapter " Use ".

5.2. Pre-programming the Somfy io local control point

Press the Up and Down buttons simultaneously the awning
-
makes a brief movement, the Somfy io local control point
has been pre-programmed in the motor.

5.3. Checking the direction rotation of the motor

Press the Up button:
1)
If the awning is raised, the direction of rotation is
a)
correct: go to chapter "Setting the end limits".
If the awning is lowered, the direction of rotation is
b)
incorrect: Press the "my" button until the awning makes a
movement, the direction of rotation has been modified.
Press the Up button to check the direction of rotation.
2)
4
1
a
b
2
Copyright © 2010 Somfy SAS. All rights reserved.
ON
Programming the
first Somfy io local
control point
or
c d
Pre-programming the
Somfy io local control
point
Use
Setting the end
limits