Maintaining Your Vacuum; Emptying The Dust Cup; Cleaning The Filters - Shark Rocket HV380 Serie Manual De Instrucciones

MAINTAINING YOUR VACUUM

IMPORTANT: Clean the dust screen
inside the dust cup as required.
NOTE: Empty dust cup when debris
reaches the MAX fill line.
13
s h a r kc l e a n . c o m

EMPTYING THE DUST CUP

1
Press the Wand Release button on
the top of the wand to disconnect
the handheld vacuum from the wand.
OR
To remove the dust cup from the
handheld vacuum, squeeze the two
Dust Cup Release buttons on both
sides of the base at the same time,
then pull out the dust cup.
2 Hold dust cup over a trash bin and
press the Empty button on the front
of the dust cup. The bottom lid will
open, allowing the debris to fall out.
3 Once dust cup is empty, close the
bottom lid and insert dust cup back
into handheld vacuum until you hear
it click into place.
Empty
Dust Cup
Release
RECOMMENDED FILTER CLEANING
SCHEDULE:
Pre-Motor Filter Kit
(Foam & Felt)
XPMFK320
Clean once a month.
Post-Motor Filter
XPSTFH380
Clean once a year.

CLEANING THE FILTERS

1 Pre-Motor (foam and felt):
Lift the latch on the top of the
handheld vacuum to open the filter
cover. Take out filters and tap loose
dirt off them. If more cleaning is
needed, rinse filters with water only
and let them air-dry completely.
To reinstall them, insert the felt
filter first, place the foam filter on
top of it, and close the filter cover.
2 Post-Motor:
Access the Post-Motor filter under
the handle. Remove and rinse the
filter with water.
Clean Filter
s h a r kc l e a n . c o m
Foam
Felt
14