ESAB Origo Arc 250 edw Manual Do Usuário página 27

Protect the machine from rain and do not put it in a location where there is danger of
flooding. Water infiltration can cause short circuits, which can be dangerous for persons
and can damage the machine.
The degree of protection, of the machine is written the rating plate and in this
manual at the "Technical Data".
Make sure that the machine does not move during operation.
Before moving the machine turn off the engine and disconnect all cables, which could
impede the move.
If the surface is not level be sure that the angle of the machine does not exceed the
values shown in the drawings below.
4.2.2 Ventilation
Use in open space with fresh air flow or vent exhaust gases, which contain the deadly
carbon-monoxide, away from the work area.
Assure that the hot air and/or exhaust gas from the machine are vented and are not
recirculated in the machine. Hot air and/or exhaust gas which is recirculated wll cause
overheating of the machine and poor combustion in the engine.
Right Right
Wrong
- 27 -