Initial Start-Up; Main Power Switch; Light Switch Lights; Digital Display / Temperature Control - Federal TSSM2454SC-3 Instrucciones De Instalación Y Operación

Initial Start-Up

After completing the items in the installation section of this manual. The case is ready
to be put into service.
TSSM2454SC-3 case is designed to operate at 38º to 40º F. (3.3° to 4.4° C) under ambient
conditions not to exceed 75º F. (23.9° C) and 55% relative humidity.
When starting a warm case, it is recommended that the temperature control setting is in the
middle of the range, such as set point 5. After the unit has gone through several cycles, adjust
the control to a warmer or colder setting to achieve the desired product temperature. NOTE:
Allow refrigerated models to run for at least two hours before placing pre-chilled product in the
case.
Nearly all open refrigerated merchandisers operate better when loaded with product than
when empty. If a check is made of the case operating temperatures, perform this check
with product in the case.
Open refrigerated merchandisers are not intended as storage refrigerators and will not "pull
down" room temperature products efficiently. Load case interior with pre-chilled product
only 38º F. (3.3° C) or less.

Main power Switch

Turn Power Switch On. The power switch is located on the inner front top left panel in front of
the refrigeration control. This switch turns off all components in the case.

Light Switch Lights

Turn Light Switch on. The light switch is located in the top duct, behind the air discharge duct.
This switch operates the interior lights only.
Digital Display - Temperature Control
Set Control to desired setting as explained in the Electronic Control section of this
manual.
The Display shows the control setting number.
The temperature control is located on the inner front top left panel behind the main power
switch.

Placing Product in Case

Allow case to cool down by letting it run at least 30 minutes before placing product into
case.
Do not overload the case with product to a point where the top air discharge grill or the
bottom air intake grill are blocked, or where the air curtain created by the discharge air is
blocked.
LOAD CASE WITH PRE-CHILLED 38ºF (3.3° C) OR COLDER P RODUCT ONLY.
THIS CASE DESIGNED TO DISPLAY ALL UNPACKAGED FOOD AND BEVERAGE.

Energy Saving Night Curtain

This unit is equipped with an energy saving night curtain.
The night curtain is located in the top inside front of the canopy.
To use the night-curtain pull down and hook onto bracket located in the center of the
front panel just below the clear acrylic air deflector when case is not in use.

Evaporator Fans

This unit is equipped with 24V DC evaporator fans. They are wired to run continuously
when power is supplied to the unit.
Deck Price Tag Holder
The deck price tag holder assembly is positioned in the front of the deck pan.
Do not cover the air return grille at the front of the deck with this part.
Case performance will be affected.
Refrigerated Self-Serve Merchandiser (High Profile) Page 11