Periodic Maintenance; Cleaning Condenser Filter - Federal TSSM2454SC-3 Instrucciones De Instalación Y Operación

PERIODIC MAINTENANCE

Cleaning the Condenser Filter
This refrigerated case is equipped with a reusable condenser coil filter, which filters
large dust particles from the air before it enters the condenser coil fins. It is very
important that this filter be cleaned monthly to maintain proper refrigeration performance
and prevent compressor failure. There is a flashing LED indicator that will flash if the
filter is not cleaned at 45 day intervals. FAILURE TO CLEAN THE CONDENSER
FILTER WILL VOID THE COMPRESSOR WARRANTY.
1. Locate condenser air filter located behind the top valance and disengage the (2)
latches on each side of filter by flipping levers out and pull down on filter. If the LED
indicator is flashing, it will stop when the filter is removed for cleaning. This is
because the clean condenser reset magnet is disengaged.
2. Wash the filter using warm soapy water. Rinse the filter and let it dry. NOTE: Do not
clean the filter in a dishwasher.
3. Apply a generous coat of filter adhesive to both sides of the filter. Recommended
filter adhesive is Federal Ind. PN 22-21164 available from Partstown. The filter is
pre-coated from the factory with this product.
NOTE: Failure to coat the filter with a fresh coat of filter adhesive after
cleaning will cause ineffective filter operation. This will lead to plugging of the
condenser coil, affecting refrigeration performance and can cause compressor
failure.
4. It is also necessary to check and clean the front of the condenser coil every 6
months or as necessary. Refer to the instructions outlined on page 14 in Cleaning
Condenser Coil.
5. Reinstall the filter. This will reset the LED reminder.
Refrigerated Self-Serve Merchandiser (High Profile)
INDICATOR LIGHT CLEAN CONDENSER FILTER
CLEAN CONDENSER FILTER RESET MAGNET
CONDENSER FILTER lATCHES (2)
Page 13