Cleaning Instructions; Daily Cleaning - Federal TSSM2454SC-3 Instrucciones De Instalación Y Operación

CLEANING INSTRUCTIONS

Acrylic Air Deflector Cleaning
NOTICE:
NEVER USE paper towels (wet or dry) for cleaning or drying and never use a dry towel.
NEVER USE glass cleaner of any kind.
Lightly dust (not wipe) surface with a damp Micro Fiber towel or chamois. The surface can then be
washed using a small amount of dishwashing detergent such as Dawn or Joy and lukewarm water. Use a
Micro Fiber towel or chamois, applying only light pressure. The cloth or chamois must be kept free of
grit by frequently rinsing. Rinse surface with clear water and dry by blotting with a damp Micro Fiber
towel or chamois.

Daily Cleaning

The case should be cleaned thoroughly, as described in the weekly cleaning section, before it is
used for the first time.
NOTICE:
NOTICE:
NOTICE:
Note: For major spills or foreign material buildup use complete weekly cleaning instructions.
Note: Detergents are not recommended and do not use abrasive cleaners or pads to prevent
scratching of surfaces.
1. Saturate a rag in warm soapy water and ring out thoroughly. Wipe the complete interior of
case and dry with soft dry towel.
2. The remaining exterior surfaces should be wiped down using any ammoniated
cleaners or soapy warm water and dried with a soft dry towel.
3.
IMPORTANT: Cleaning the clear acrylic plastic front air deflector requires
special care to prevent hazing and yellowing of material. Clean as described in
"Acrylic Air Deflector Cleaning" section of this manual.
Refrigerated Self-Serve Merchandiser (High Profile)
Clear acrylic air deflector requires special washing procedures to
prevent hazing and yellowing of material.
Avoid splashing or soaking any electrical components with water to
prevent electrical damage to the case.
Shut off lights and power switches and remove all products from case.
Allow sufficient time for the unit to reach room temperature before
proceeding with cleaning.
Remove all products from the case before proceeding with cleaning
procedure.
Page 19