Adjustment Of Wind Direction - Toshiba MMY-MAP0501HT8-E Manual Del Propieratio

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 98
4
CORRECT USAGE
[In case of cooling]
• Start the cooling operation after approx. 1 minute.
[In case of heating (For Heat-pump model only)]
• The heating operation mode is selected in accordance with the room temperature and operation starts after
approximately 3 to 5 minutes.
• After the heating operation has stopped, FAN operation may continue for approx. 30 seconds.
• When the room temperature reaches the set temperature, the super low wind is discharged and the air volume
decreases excessively.
• During defrost operation, the fan stops so that cool air is not discharged. ("
NOTE
When restarting the operation after stop
• When restarting the operation immediately after stop, the air conditioner does not operate for approx. 3 minutes
to protect the machine.
5

ADJUSTMENT OF WIND DIRECTION

For best cooling and heating performance, adjust the louvers (adjustment of up/down wind direction) appropriately.
• If cooling operation is performed with downward air outlet, dew may fall on surface of the cabinet or the
horizontal louver resulted in dripping.
• If heating operation is performed with horizontal air outlet, unevenness of temperature may increase in the room.
• Do not move the horizontal louver directly with hands; otherwise a trouble is caused.
Select direction of the horizontal louver using
The horizontal louver does not stop immediately even if the switch is pushed.
Adjusting the stop position, push the switch.
K
For all models
[In Cooling operation]
Use the louvers with horizontal set point.
[In Heating operation (For Heat-pump model only)]
Use the louvers with downward set point.
K
For Under Ceiling, 1-way Air Discharge Cassette, High Wall Type
[Right / Left air direction adjustment]
To change the air outlet direction to right or left side, set the vertical louver inside of the horizontal louver to the
desired direction.
English-11
CAUTION
SWING/FIX
switch on the remote controller.
11
PRE-HEAT" is displayed.)

Publicidad

Tabla de contenido
loading

Tabla de contenido