K
4-way Air Discharge Cassette Type
(2H series only )
TEMP.
TIMER SET
TIME
FILTER
LTER
L
RESET
TEST
SET
1
n How to set louver wind direction individually
1
Select an indoor unit to be set by pushing
UNIT LOUVER
(left side of the button) during operation.
• The indoor unit number changes each time you
push the button.
Unit No. 1-1
Unit No. 1-2
No display
∗ When no unit number is displayed, all indoor units
are selected.
2
Select a louver you want to adjust change by
UNIT LOUVER
pushing
(right side of the button).
• Each time you push the button, the display on the
left of the remote controller changes as follows:
∗ When no louver number is displayed, all four
louvers are selected.
Louver No.
Refrigerant pipe
04
Drain pipe
Unit select
3
button
ON / OFF
FAN
MODE
SAVE
A
AVE
VENT
CL
SWING/FIX
UNIT LOUVER
T
Unit No. 1-3
Unit No. 1-4
No
display
03
01
3
Determine wind direction of the selected
louver by pushing
• Each time you push the button, the display
changes as follows:
(1)
2
∗ During COOL (DRY) mode, (4) and (5) are not
displayed.
u 2-way Air Discharge Cassette, 1-way Air
Discharge Cassette Type (1YH series)
TEMP.
FILTER
LTER
L
RESET
TEST
Unit No. 1-1
Setup of air direction and swinging
1
SWING/FIX
Push
• [SWING
automatically changes upward/downward.
In case when one remote controller controls the
multiple indoor units, each indoor unit can be
selected and its air direction can be set up.
2
SWING/FIX
Push
the louver.
• The air outlet louver can be stopped at the
desired position.
3
UNIT LOUVER
• To set up the air direction individually, push
02
UNIT LOUVER
a group control. Then set up the air direction to a
displayed indoor unit.
• If there is no display, all the indoor units can be
operated collectively.
• Every pushing
exchanges as shown in the figure.
14
SWING/FIX
.
(2)
(3)
(7)
(6)
(5)
ON / OFF
TIMER SET
FAN
TIME
SAVE
AVE
A
SET
CL
SWING/FIX
1, 2
Unit No. 1-2
No display
Unit No. 1-4
button during operation.
] is displayed and the air direction
button again during swinging of
button to display each indoor unit No. in
UNIT LOUVER
button, the display
(4)
MODE
VENT
UNIT LOUVER
T
3
Unit No. 1-3
English-14