INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
INTENDED USE
The Oscillating Flange is designed to operate as an oscillating water device by mounting a fixed monitor to the outlet of the flange and is intended to
provide efficient trouble-free operation. The oscillating flange is intended to be deployed for unmanned operation. The following instructions are provided
to assist in obtaining the best possible performance from this unit. Read and understand these operating instructions before use.
All illustrations are shown with the Style 3528 Omega™XP monitor and Style 4461 Rampage ™Nozzle. The operation of the oscillating flange is not
limited to this monitor and nozzle.
PRODUCT RATINGS
Mass: 126.5 lb. (57.5 Kg)
Maximum Flow:
1250 gpm (4800 lpm) @ 250 psi (1725 Kpa, 17.2 bar),
1500 gpm (5700 lpm) @ 180 psi (1240 Kpa, 12.4 bar)
Maximum Pressure: 250 psi (1725 Kpa, 17.2 bar)
Minimum Pressure: 50 psi (345 Kpa, 3.4 bar)
Oscillation Speed: Up to 40° / second
PRODUCT WARNINGS
WARNING: Do not lift the oscillating flange by the stainless steel guard.
WARNING: Operating the oscillating flange at pressures higher than 180 psi with flows greater than 1250 gpm may
damage the oscillation mechanism.
WARNING: Charge the unit slowly. Rapid charging many cause a pressure surge with the potential to cause injury or
damage to the unit.
WARNING: Aim the unit in a safe direction before pumping water through it.
WARNING: Replace the identification tag and warning tag if they should become worn or damaged.
WARNING: Do not exceed the maximum pressure or flow ratings of the oscillating flange. Exceeding these ratings
may lead to an injury or may cause damage to the oscillating flange.
WARNING: Drain the unit after use to prevent freeze damage.
WARNING: Keep all personnel out of the WATER DISCHARGE AREA (Figure 2), in front of the outlet of the monitor,
when the water source is attached. Dangerous flow velocities can cause serious injury.
STYLE 3531 OSCILLATING FLANGE
122122