Rotation Direction - Akron Brass 3531 Instrucciones De Instalación, Funcionamiento Y Mantenimiento

CRANK ARM POSITION:
If the monitor is not capable of rotating 360º, orient the monitor so that the monitor can be adjusted to align with the target. The position of the CRANK
ARM must be considered when installing the monitor. The position of the CRANK ARM will indicate how far away from center to point the nozzle and in
which direction to aim the nozzle. Remove the ANGLE ADJUSTMENT LID (Figure 1) from the guard. If the crank is located near either of the two positions
shown in Figure 3, aim the nozzle directly at the target.
Figure 3
CENTER NOZZLE ON TARGET WITH CRANK
ARM IN EITHER POSITION SHOWN.
NOTE:
ANGLE ADJUSTMENT LID IS REMOVED
FROM GUARD IN THIS VIEW.
THE OSCILLATION MECHANISM IS AT
THE CENTER OF OSCILLATION WHEN
THE CRANK ARM IS IN EITHER OF
THESE POSITIONS.

ROTATION DIRECTION