Sirius SCISIU24TC Istrucciones De Uso página 21

TIMING
As a result of the new EU65 "Energy label" and
EU66 " Ecodesign" regulations issued by the
European Commission, which came into force
as from January 1st, 2015 , our products have
been adapted to comply with these new re-
quirements.
All of the models complying with the energy
label requirements, are equipped with new
electronics including a timer device for suc-
tion speeds control, when the air capacity ex-
ceeds 650m³/h.
Internal motor models, with maximum air
capacity higher than 650m³/h, are equip-
ped with a timer device that automatically
switches the suction speed from 4th to 3rd
speed, after 5 minutes operation.
External motor models are equipped with re-
mote motors that , as for internal motor ver-
sions, include a timer device that switches
down the suction speed when it exceeds 650
mᵌ/h. (See External Motors Instructions ).
Remote motors, whose air capacity exce-
eds 650m³/h at both 4th and 3rd speed, will
have the following by default timer control
functions: The suction speed is automatical-
ly switched from 4th to 2nd speed, after 6
minu tes operation.
If the appliance is working at 3rd speed, it
is automatically switched to 2nd speed, after
7 minutes operation. Operation speeds can
also be changed during operation.
The energy consumption of the appliance in
stand – by mode is lower than 0.5W.
MAINTENANCE
* An accurate maintenance guarantees good
functioning and long-lasting performance.
* Particular care is due to the grease filter
panel. It can be removed by pushing its spe-
cial handle toward the back-side of the coo-
ker hood and turning the filter downwards so
to unfasten it from its slot (Fig. 4A).
To insert the filter just perform the opposite
operation.
After 30 hours working (model SIL-Module
luxury version), the push button control pa-
nel will signal the saturation of the grease fil-
ter by lighting all the buttons.
In the SILTC models (Touch Control Version)
the grease filter saturation is signalled by the
flashing of the two central push buttons (Fig.
16C). Press the timer button to reset
The grease filter needs cleaning by regular
hand-washing or in dishwasher every two
months at least or depending on its use.
* In case the appliance is used in its filtering
version, the active coal filter (Fig. 12Z - 13Z)
needs to be periodically replaced. The coal
filter can be removed by removing the gre-
ase filter first (Fig. 4A-12B), and by pulling
its special plastic tongue until it is unfaste-
ned from its slot. Re-insert the coal filter by
operating in the opposite way. The coal filter
needs replacing depending on the use, but
however every six months at least.
* To clean the appliance itself tepid water
and neutral detergent are recommended,
while abrasive products should be avoided.
For steel appliances specialized detergents
are recommended (please follow the instruc-
tions indicated o the product itself to obtain
the desired results).
* To replace the halogen lamps, remove first
the glass-blocking ring (Fig. 14A), by leve-
ring with a screw-driver and thus removing
the opaque glass (Fig. 14B) - when perfor-
ming this operation hold the opaque glass
carefully. Remove the lamp (Fig. 14C) without
touching it with uncovered hands. Replace it
with another lamp of the same kind.
After the replacement, re-insert the glass-
blocking ring and fasten it. To replace the
dichroic lamp, remove the lamp (Fig.15) and
replace it with a lamp of the same kind.
To replace the round or square LED lamps,
you have to check first if it is possible to ac-
cess the back side of the lamp with your hand
(Pic. 19).
If it is possible to access the back side of the
lamp, you have to: insert your hand , push at
the same time both support wings of the lamp
(Pic. 20), push to remove the lamp (Pic. 21).
If it is not possible to access the back side of
the lamp, you have to: provide yourself with
a sharp utensil, insert the utensil between the
lamp and the stainless steel frame (on the
side where the little support wings are pla-
ced), push to remove the lamp from the coo-
ker hood (Pic. 22).
21
.