Moving The Wet/Dry Vac; Blowing Feature - RIDGID WD7000 Manual Del Operador

Operation (continued)
Dust
Drum
Axle
Support
5. Replace the drum by reinserting into
the cavity and push until it snaps into
place.

Moving the Wet/Dry Vac

To maneuver the Vac, the metal handle in
the rear of the unit should be positioned
in the upright position for ease of
movement. Be sure to unlock the back
wheels by pulling up on the wheel locks
before moving the Vac.

Blowing Feature

Your Vac features a blowing port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a blower.
1. Locate blowing port of your Vac.
!
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
!
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
!
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
!
CAUTION: To reduce the risk of
hearing damage wear ear protectors
when using the Vac/blower for
extended hours or when using in a
noisy area.
TC AR T
SM AR
Pull Down and
Slide Dust Drum
Out of Wet/Dry
Vac Unit
Drain
Locking End
Blowing Port
2. Insert the locking end of the hose
assembly into the blowing port of the
Vac. The hose should snap into place.
To remove the hose from the Vac,
press the release button in the hose
assembly and pull the hose out of the
Vac inlet.
3. (Optional) Attach extension handle to
opposite end of hose, then place the
crevice tool on the wand.
4. Turn Vac on and you are ready to use
your Vac as a blower.
12
Pull Up to Unlock
Wheel Locks
Hose
Assembly