Brinkmann Vertex Sear Manual Del Propietário página 13

MATCH LIGHTING THE VERTEX SEAR BURNER:
1. Open lid before lighting Vertex Sear burner.
2. Turn the Vertex Sear burner control knob to "OFF".
3. Strike and carefully place a match approximately 1/2" (1 to 2 cm)
from the burner.
4. Turn the Vertex Sear burner control knob to the "ON" position. The
burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait
5 minutes for gas to dissipate and repeat lighting procedure.
6. If the burner does not light within the first few attempts of match
lighting, there is a problem with the gas supply. Turn off the gas at
the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected. See "Trouble Shooting" section of
this manual.
Note: Observe flame height when lit: Flame
should be a Blue/Yellow color between
1"– 2" when burner is on " HIGH".
TURNING OFF THE GRILL:
1. Turn off the cylinder valve.
2. Turn all burner control knobs to the "OFF" position.
Note: Turn off LP cylinder first to prevent gas from being left in the
system under pressure.
CAUTION!
• The cylinder valve should always be in the off,
or closed, position when the grill is not in use.
To turn off the cylinder valve,
turn knob clockwise until it stops.
12