Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Aim the "Temperature Measurement sensor"
2.5cm (1 inch) from the top or sides of the
battery case and press <<ENETR>>. Measured
temperature may vary by distance from the
battery, under hood conditions, and cabinet
temperature.
6.
Testing battery.
7.
When the test is completed, the display shows
the results as following.
8.
Press ENTER to print the
result.
VM/AM TEST
AM TEST
1.
Install the 9V battery.
2.
Connect Clamp Meter to the jack A on
BT2100. Press POWER.
3.
Press the button ZERO. Make sure the display reads zero.
4.
Press the trigger to open the transformer jaws and clamp one
electrical wire.
5.
Make sure the clamp jaw is perfectly closed.
6.
Read the displayed value.
VM TEST
-
-
17
Publicidad
Tabla de contenido
