Simu DMI5 Hz Manual De Usuario página 9

If you do not want to use this transmitter as the individual control:
- cut the power supply (2 seconds minimum).
- repeat the opération 4.1* with a new transmitter and then go to step §5.
Programming the first individual control point
5
This operation can only be performed from the transmitter that was used for operation 4.1.
- Press the transmitter PROG Key for approximately one second.
The motor will run for 0,5 second in one direction and then in the other.
Your transmitter is now programmed to control the motor in stable mode.
Programming a new (individual, group or general) control point
6
6.1- Open the memory of the receiver from the control
transmitter:
- Press the PROG key of the transmitter for about 3 seconds. The
motor will run for 0,5 second in one direction and then in the other.
6.2- Confirm the operation from the new transmitter
you want to program:
- Press the PROG key of the transmitter for 1 second. The motor
will run for 0,5 second in one direction and then in the other.
- For group controls, repeat operations 6.1 and 6.2 for each motor in the group.
- For general controls, repeat operations 6.1 and 6.2 for each motor in the installation.
- To delete an transmitter from the memory of a motor, perform operations 6.1 with a programmed transmitter, then perform
the operation 6.2 with the transmitter to be deleted.
Programming a sensor
7
7.1- Open the memory of the motor from the individual
control transmitter:
- Press the PROG key of the transmitter for about 3 seconds until the
motor jogs in both directions.
7.2- Confirm the operation from the sensor you wish to
add:
- Press the PROG key of the sensor less than 1 second. The motor
will jog in both directions.
- For group controls, repeat operations 7,1 and 7,2 for each motor in the group.
- To delete a sensor from the motor's memory: Perform operation 7.1 from the individual control transmitter and operation 7.2
from the automatic control to be deleted.
Recommendations when using a sensor: If the Wind sensor on an installation is changed or deleted, it is important to
delete it from the memory of all the motors in which it was programmed: perform operations a with a programmed transmitter,
then perform the operation b with the sensor to be deleted.
1
PROG 1s.
1
PROG ≥ 3s.
2
PROG ≤ 1s.
1
PROG ≥ 3s.
2
PROG ≤ 1s.
4/5