Section 9.0 Cleaning; Cleaning The Headpiece Assembly - BETCHER INDUSTRIES WHIZARD Power Knife Manual Del Usuario

Operating
Instructions
SECTION 9.0
9.1

Cleaning the Headpiece Assembly

IMPORTANT: For all cleaning operations, Power Knife MUST be disconnected from the power
supply. BE CAREFUL when handling the sharp blade.
To take Headpiece Assembly apart for cleaning or for
maintenance, remove the two knobs and bolts. All parts can
now be removed from the frame.
CAUTION: Handle blade carefully, as the inner edge is SHARP!
To remove the blade from the blade housing, place
housing on table with blade edge down. Spread housing
open and lift away from blade.
NOTE: DO NOT use cleaners which contain lemon oils,
Examine all parts for wear or breakage. Replace as necessary. A shipping box has been included as part
of the Power Knife kit in which to send parts for replacement.
Reassemble in reverse order, making sure blade is free to rotate in the blade housing and meshes
properly with teeth on drive pinion.
Re-adjust depth gauge setting and re-adjust blade housing following instructions given.
Bettcher Industries, Inc.
Cleaning
as they may damage the finish of your tool
To remove the Headpiece Assembly from the Motor Unit,
hold the Motor Unit in one hand and rotate the Headpiece
Assembly one quarter-turn counterclockwise with the other
hand. Then withdraw it from the end of the Motor Unit.
The drive pinion may be removed now.
Clean all parts using a mild detergent solution. A scrub
brush is useful for cleaning the gear teeth on both the
blade and the drive pinion, and for inside the blade
.
housing
Page 13
Whizard® Power Knife Manual
Rev. January 29, 2016