Unpacking And Assembly; Ventilation; Connecting To Gas Supply; Assembly - Mi-T-M MH-0018-0M10 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

UNPACKING AND ASSEMBLY

1. Remove heater and base from Carton (Save
carton and packing materials for later storage).
2. Remove all protective packaging protecting
heater during shipping.
3. Place Heater Base on flat surface with wheels
on ground.
4. Line up holes in bottom of heater cabinet with
locking tabs on top of base.
5. Mount heater cabinet to heater base sliding
tabs through holes in bottom of cabinet and
sliding cabinet backward approximately ¼" or
until cabinet will not move further back.
6. Use thumbscrews to attached heater cabinet
to heater base.
7. Inspect heater closely for any damage that
may have occurred during shipping. If there is
any damage, return the heater to the place of
purchase.
8. Slip the protruding safety guard ends through
the holes in each side wind cover. (A)
9. Be sure the metal tabs are situated above the
safety guard bar. (B)
10. Fold the tabs down over the saftey guard bar
to secure the wind covers. (C)
11. Affix the assembled safety guard and wind
covers to the reflector by inserting the protruding
ends of the safety guard into the mounting holes
in the reflector.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A FUEL
SOURCE.
WARNING: THIS HEATER IS NOT INTENDED FOR
RESIDENTIAL USE.

VENTILATION

Caution: Always provide a fresh air opening in the heated
space of at least three square feet (2,800 sq. cm) for each
100,000 BTU/Hr. of heater output. Provide a larger opening
if more heaters are being used. As an example, a MH-0018-
0M10 heater will require:
a two-car garage door open 2 inches, or
a single car garage open 3 inches, or
two thirty two inch wide windows open 4 inches

CONNECTING TO GAS SUPPLY

CAUTION: THE PROPANE (LP) GAS PRESSURE REGULATOR AND HOSE ASSEMBLY SUPPLIED
WITH THE HEATER MUST BE USED WITHOUT ALTERATION.
CAUTION: BE SURE TO INSPECT THE REGULATOR HOSE BEFORE EACH USE. IF THE HOSE IS
CUT OR FRAYED, REPLACE IT WITH THE MANUFACTURER SUGGESTED ASSEMBLY.
Propane Heater Manual

ASSEMBLY

A
B
Regulator
LP Cylinder
Valve
Coupling
Nut
13
C

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido