Displaying The Instrument Data - MSA ALTAIR Manual De Operación

OPERATION
3.3.

Displaying the instrument data

(1) By pressing the [TEST] key, the stored instrument data can be called up
( Fig. 5).
This includes:
 the current gas concentration
 the test gas mode
 the value for the lower reaction point ("
 the value for the upper reaction point ("
 the minimum oxygen concentration ("
the measured peak values ("

During the display of the peak value, press the [TEST] key:
Value is deleted

CLR
 "
 The alarm duration in hours (hour glass, "
 The IR mode
 If an IR interface is detected in the test mode, the instrument bypasses
the IR mode.
 If no IR interface is detected in test mode within 30 s, or the [TEST] key
is pressed, the instrument exits this mode.
16
The measured peak values can be deleted. For this, press the test
button when displaying the relevant value.
" is displayed
ALTAIR Operating Manual
LO ALARM
" "
HI ALARM
" "
LO
") – only for oxygen version
HI LO
", " ")
HRS
" and numeric value)
")
")
MSA
GB