Malfunctions And Troubleshooting; Surface Treatment; Dismantling; Declaration Of Performance - HST 42 Instrucciones Para El Montaje, Funcionamiento, Mantenimiento Y Desmontaje

Guías ds para puerta seccional de apertura lateral
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
ENGLISH
The following inspection and maintenance tasks must be
carried out by a specialist in accordance with these
instructions, before initial operation and at least once a
year.
6 .1 .1
Fixing points
Check all the fixing points on the door and the building
structure and make sure that all the fastenings are
securely seated and, if necessary, retighten.
6 .1 .2
Rollers and tracks
Rollers must rest evenly on the track (see Figure 6).
Adjust rollers if necessary. Observe the operator fitting
notes; they contain details on roller adjustment.
Clean tracks, if necessary, do not grease!
6 .1 .3
Check the floor rail and floor guide
rollers
Clean the floor rail and floor guide rollers.
Check the rollers for wear. Have the rollers replaced by
a specialist if they are greatly worn or damaged.
6 .1 .4
Hinges and roller holders
Oil hinges and roller holders.
6 .1 .5
Seals
Check for damage, deformations and completeness.
If necessary, replace.
6 .1 .6
Locking cylinders
ATTENTION
Damage to the locking cylinders due to unsuitable
cleaning products
Locking cylinders may not be cleaned with agents
containing oil or be oiled.
Only use specialised care products.
Do not use oil or graphite.
7
Malfunctions and
Troubleshooting
WARNING
Danger of injury due to uncontrolled door movement
If the door malfunctions, uncontrolled door movements
may trap persons or objects.
In the event of a door failure (sluggish operation
or other malfunctions), a specialist must be
commissioned immediately for the
inspection / repair work.
10
7 .1

Surface treatment

If you would like to paint the door in a different colour,
renovation painting or additional protective painting is
required.
7 .1 .1
Doors with primer-coating
Gently sand the surface with fine grained sandpaper
(at least 180 grain size).
Clean with water, dry, degrease
Follow with standard paint for exterior use
Follow the directions provided by the paint
manufacturer
Avoid dark coatings on doors.
7 .1 .2
Doors with primer-coating
Gently sand the surface with fine grained sandpaper
(at least 220 grain size).
Clean with water, dry, degrease
Follow with standard paint for exterior use
Follow the directions provided by the paint
manufacturer
Avoid dark coatings on doors.
8

Dismantling

Dismantle the door in accordance with these fitting
instructions, in the logically correct reverse order.
9

Declaration of performance

Declaration of performance see
Figure 8 .4:
Data label
4 018 371 RE / 02.2020

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

20 serie

Tabla de contenido