SFA SANICOMPACT Silence ECO+ Manual De Instalación página 26

AU
1
DESCRIPTION
This device is (manufactured in a
factory which is quality) certified to
ISO 9001, ISO 14001. This device is not
designed for persons (including children)
with limited physical, sensory or mental
abilities, or those with minimal experience
and knowledge, unless they are monitored
and are given the necessary instructions for
using the device, with the help of a person
responsible for their safety. Monitor children
and make sure they do not play with the
device.
2
APPLICATIONS
Sanicompact ® is a specially designed WC with
an integral pump / macerator to discharge WC and
washbasin waste*. (*: depending on the model).
To view the DoP (Declaration of performance)
please click on the 'Illustrations and Datasheet'
tab on each product page on our website.
3
INSTALLATION
The fitting and working of your appliance must meet
local plumbing regulations and the AS3500.2.12
To optimise the latest technical developments
concerning soundproofing incorporated into this
unit, it is important to:
• position the WC pan so that it is not in contact
with a partition or wall of the room
• place the WC pan on a perfectly level surface
• fix the discharge pipe correctly, with distances of
not more than one metre between the fastenings.
CONNECTION TO THE WATER SUPPLY
Connect the water supply hose to a shut off valve.
Caution: The quality of the rinsing of the bowl
depends on the water pressure.
WARNING: for correct flushing, the water pressure
must be a minimum of 170 Kpa . Note:
In an area where water is not pure (dirty,
sandy), we advise you to add a filter between the
shut off valve and the toilet to prevent clogging
of the solenoid valve.
4
CONNECTION TO THE
ELECTRICAL SUPPLY
The electrical installation should be
carried out by a qualified person. The
unit requires a 220/240V single phase AC 50
Hz supply (AU specification). The power supply
circuit of the appliance must be earthed and
protected by an RCD with sensitivity (30mA) on
a 16 amp circuit.
All wiring & GPO positions must
conform to Australian Standards for
electrical wiring AS3000:2007
requirements for electrical installations.
5
COMMISSIONING THE UNIT
Connect to the power supply. Wait 20 seconds:
appliance initializing.
Open the water tap to rinse well. Start the nor-
mal flush by pressing the dark grey button. Put
a few sheets of toilet paper down in the bowl
and flush again.
PROGRAMMING
SANICOMPACT® Eco is controlled by an elec-
tronic programmer. Duration of operation varies
according to the cycle chosen.
- Eco flush (light grey button)
- Normal flush (dark grey button)
You can lengthen the rinse if the default flush is
not enough.(Low supply pressure)
To re-programme:
• Press the two grey buttons at the same time
for 5 seconds. (model without wash basin option)
• Press the dark grey button for 5 seconds
(model with wash basin option)
• The motor runs for 2 seconds, this means you
have entered programming mode.
• Each time you press the dark grey button you
increase the length of the flush by 1 second: each
time you press it will be validated by the motor
SANIFLO MANUFACTURER WARRANTY
This warranty is provided by Saniflo Australasia Pty Ltd (ABN 55128147240), 10/25
Gibbes Street, Chatswood NSW 2067. Tel: 1300 554 779, email info@saniflo.com.au.
GENERAL TERMS AND CONDITIONS
This product is to be installed and operated in accordance with the instructions provided.
Saniflo warrants its products to be free of defects in material and workmanship during
he warranty period. If a product proves to be defective in material or workmanship during
the warranty period, then Saniflo will, at its discretion, repair or replace the product
with a like product. Replacement product or parts may include re-manufactured or
refurbished parts or components. Rights under this warranty sit alongside consumer
guarantees under Australian Consumer Law which cannot be excluded.
Warranty service work may be denied or suspended on
equipment not readily accessible to service personnel.
How long the warranty is effective:
This product is warranted for 24 months for parts and labour from the date of purchase
by the end user.
To obtain warranty service:
Contact Saniflo on 1300 554 779
Ensure the product is still installed at the original location Provide proof of original
purchase, customer name and address, and the installing plumber's details.
7
GUARANTEE
Only the disposal of toilet paper, faecal matter, and waste water will be under warranty.
Dsiposal of solvents, paint, acids, caustic liquids, harsh chemical, hair, food, cotton,
condoms, sanitary towels, metal, wood, plastic or any foreign objects will void the warranty. The
usage of Grease or oil will also void the warranty.
24
running for a short period.
• Each time you press the light grey button you
decrease the length of the flush by 1 second:
each time you press it will be validated by the
motor running for a short period.
To exit programming mode:
• Do nothing for several seconds
Note : Duration of operation varies according to
the cycle chosen.
Operating wash basin: Please make sure that the
wash basin tap draining into the sanicompact is
properly shut off after usage and not dripping.
6
MAINTENANCE
WARNING !!! In the event of prolonged absence it
is essential to turn off the Power and water supply.
CARE OF YOUR UNIT
In order to remove scale and clean the macerator
and the bowl, use the SANIFLO descaler.
.Disconnect the macerator power supply,
.Pour the required amount of cleanser into the pan
.Leave it to stand for 1 or 2 hours,
.Re-connect the macerator power supply,
.Rinse by operating the flushing system twice. Carry
out the operation once every 3 months on average.