Technical Data - ALPHA-TOOLS TK 200 Manual De Instrucciones

Anleitung TK 200 31.10.2001 13:48 Uhr
It is imperative to observe the manufacturer's
safety, operating and maintenance instructions
as well as the dimensions quoted in the

technical data.

It is imperative to observe the accident
prevention regulations in force in your area as
well as all other generally recognized rules of
safety.
Note the information published by your
professional associations (VBG 7j).
Switch on the dust extraction system each time
you use the machine.
Use the saw only with a suitable vacuum
extraction system or a standard industrial
vacuum cleaner in order to prevent injuries
caused by flying pieces of wood.
Wear goggles
Wear ear-muffs
Wear a breathing mask
Noise emission values
The saw's noise is measured in accordance with
DIN EN ISO 3744; 11/95, E DIN EN 31201;
6/93,ISO 7960 Annex A; 2/95. The noise may
exceed 85 dB(A) at the workplace. In this case,
noise protection measures need to be
introduced for the user (ear-muffs).
Sound pressure level LPA
Sound power level LWA
„The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immission
Seite 13
level at the workplace include the duration of impact,
the type of room, and other sources of noise etc.,
e.g. the number of machines and other neighbouring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved."
5. Technical data
Asynchronous motor
Power rating
Temporary operation
Idle speed n0
Carbide saw blade
Number of teeth
Table size
Cutting height max.
Table tilt
Connector for dust extractor
Size, complete
Packaging
Weight
6. Before putting the machine into
Cutting Idling
90 dB(A) 68 dB(A)
99 dB(A) 82 dB(A)
operation
The machine has to be set up where it can stand
firmly, e.g. on a work bench, or it must be bolted
to a strong stand.
All the covers and safety devices have to be
properly fitted before the machine is switched on.
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machine's moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
GB
230 V 50 Hz
600 W
S3 50%
2800 rpm
200 x 16 x 2.8 mm
24
500 x 335 mm
43 mm / 90°
26 mm / 45°
infinite 0 - 45°
dia. 34 mm
500 x 335 x 265 mm
560 x 360 x 290 mm
11 kg
13