On-Off Functions); Technical Characteristics - Nice Robus 350 Instrucciones Y Advertencias Para El Instalador

8) Technical characteristics

Nice S.p.a., in order to improve its products, reserves the right to modify their technical characteristics at any time without prior notice. In
any case, the manufacturer guarantees their functionality and fitness for the intended purposes.
All the technical characteristics refer to a room temperature of 20°C (±5°C).
Technical characteristics: ROBUS350
Type
Pinion
Peak thrust
Nominal torque
Nominal torque speed
Idling speed
Maximum frequency of operating cycles
Maximum continuous operating time
Operating limits
ROBUS350 Power supply
ROBUS350/V1 Power supply
Max. absorbed power
Insulation class
Emergency power supply
Flashing Light Output
BLUEBUS Output
STOP Input
Step-by-step Input
Radio AERIAL Input
Programmable functions
Recognition functions
Operating temperature
Use in acid, saline or potentially explosive
atmosphere
Protection class
Dimensions and weight
Technical characteristics Radio receiver: SMXI
Type
Frequency
Coding
Transmitter compatibility
Transmitters memorized
Input impedance
Sensitivity
Range of the transmitters
Outputs
Operating temperature
Technical characteristics transmitter: FLO2R-S
Type
Frequency
Coding
Buttons
Power supply
Absorption
Battery life
Irradiated power
Dimensions and weight
Protection class
Operating temperature
20
Electromechanical gearmotor for the automatic movement of sliding gates for residential
use, complete with electronic control unit.
Z: 15; Module: 4; Pitch: 12,6mm; Pitch diameter: 60mm
18Nm; corresponds to the ability to start a leaf with a static friction of max. 600N
moving.
10Nm; corresponds to the ability to keep a leaf with a dynamic friction max. 333N
moving.
0,18m/s
0,34m/s
50 cycles per day (the control unit allows up to the maximum described in tables 1 and 2)
10 minutes (the control unit limits the continuous operation up to the maximum descri-
bed in tables 1 and 2)
In general, ROBUS350 is suitable for the automation of gates featuring leaves up to 15 m
wide and weighing up to 350 kg, as shown in Tables 1 and 2.
230Vac (+10% +15%) 50/60Hz.
120Vac (+10% +15%) 50/60Hz.
250VA
1 (a safety grounding system is required)
With PS124 optional accessory
For 1 LUCYE flashing light (12V, 21 W lamp)
One output with a maximum load of 15 BlueBus units
For normally open contacts, for 8.2KΩ constant resistance, or normally closed contacts; with
self-recognition (any variation from the memorized status causes the "STOP" command)
For normally open contacts (the closing of the contact causes the "STEP-BY-STEP" command)
52 Ω for RG58 or similar type of cable
6 ON-OFF functions and 6 adjustable functions (see tables 12 and 14)
Recognition of the devices connected up to the BlueBUS output. Recognition of the type
of "STOP" device (Normally Open or Normally Closed contact or 8.2KΩ resistance).
Recognition of the length of the gate and calculation of the slowdown and partial opening
points.
-20°C ÷ 50°C
No
IP 44
330 x 195 h 227; 8Kg
Digital Rolling code with 53 Bit code, FLOR type
FLOR, VERY VR; only single group: ERGO, PLA-
NO, PLANOTIME, SMILO
From 100 to 150 m. The range can vary if there are obstacles or electromagnetic disturbances, and is
affected by the position of the receiving aerial
Digital Rolling code with 53 Bit code, FLOR type
1 year, estimated on the basis of 10 commands/day, each lasting 1s at 20°C (at low temperatures the
efficiency of the batteries decreases)
72 x 40 h 18mm / 30g
IP40 (suitable for use indoors or in protected environments)
Radio receiver: SMXIS
4 channel receiver for radio control devices.
433.92MHz
Digital Rolling code with 64 Bit code, SMILO type
SMILO
Up to 256 if memorized in mode 1
52Ω
better than 0.5µV
4 (on SM connector)
-10°C ÷ 55°C
transmitter: SM2
2 channel transmitter for radio command
433.92MHz
Digital Rolling code with 64 Bit code, SMILO type
2
12Vdc with 23A battery
25mA
100µW
Diameter 48 h14mm / 19g
-40°C ÷ 85°C