Intended Use - salmson SIL Serie Instalacion Y Puesta En Servicio

English
Fig. 6: Transporting the pump
Fig. 7: Transporting the motor
4

Intended use

Purpose
Fields of application
Contraindications
34
• The transport eyes on the motor are only for guiding while bearing
the load (Fig. 6).
• The transport eyes on the motor are only for transporting the
motor, and are not approved for transporting the complete pump
(Fig. 7).
WARNING! Risk of injury!
Setting up the pump without securing it can lead to personal injury.
• Do not place the pump unsecured on the pump support feet. The
base with the threaded holes is used for attachment only. When
standing freely, the pump might not be sufficiently stable.
DANGER! Risk of fatal injury!
The pump itself and pump parts can be extremely heavy. Falling
parts pose a risk of cuts, crush injuries, bruises or impacts, which
may lead to death.
• Always use suitable lifting equipment and secure parts against
falling.
• Never stand underneath a suspended load.
• Make sure the pump is securely positioned and is stable during
storage and transport as well as prior to all installation and other
assembly work.
The glanded pumps of the SIL (in-line single pump), DIL (in-line dou-
ble pump) and PBS (monobloc pump) series are meant to be used as
circulators in building services.
They may be used for:
• Hot-water heating systems
• Cooling and cold water circulation systems
• Process water systems
• Industrial circulation systems
• Heat carrier circuits
Typical installation locations are technical rooms within the building
with other domestic installations. No provision has been made for
direct installation of the device in rooms used for other purposes
(residential and work rooms).
For these series, it is possible to set them up outdoors only in their
corresponding, special version, on request (see chapter 7.3 "Anti-
condensation heater connection" on page 46).
CAUTION! Risk of property damage!
Non-permitted substances in the fluid can destroy the pump.
Abrasive solids (e.g. sand) increase pump wear.
Pumps without an Ex rating are not suitable for use in potentially
explosive areas.
• Intended use includes compliance with this manual.
• Any other use is regarded as non-compliant with the intended use.
Salmson 11/2017