Troubleshooting Procedures; Troubleshooting Table - Kohler K-1188 Guia De Instalacion

Using Your Bath (cont.)
As the pump/motor turns on and water begins to circulate, the light will change to solid green, and
will stay on as long as the overflowing bath is running.
Verify that the indicator light for the heater is on when the overflowing bath is in operation. This
indicator light is located on the underside of the heater box, and is near the subfloor at the pump
end of overflowing bath. If the light is not on when the overflowing bath is running, press the reset
button located to the right of the indicator light on the heater box.
Press the "On/Off" control switch again to turn off the overflowing bath. The orange light in the
"On/Off" switch will temporarily turn on to indicate the end of the operating mode. The green light
in the "On/Off" control switch will then start to blink automatically until the overflowing bath is
drained below the overflow channel sensors or restarted.
NOTE: A built-in timer automatically stops the bath after approximately 20 minutes of operation.
16. Chromatherapy Light Operation (if equipped)
NOTE: These directions pertain to the use of the mounted control pad only. For more information, see the
"Test the Remote Control" section.
If the chromatherapy lights are turned off, press the button on the control pad (located on the opposite side
of the overflowing bath. The chromatherapy lights will begin to cycle through each of the colors (sweep
mode).
When the chromatherapy lights are in sweep mode, you can lock in one color light by pressing the control
button.
When an individual color is locked in, press the control button to turn the chromatherapy lights off.

Troubleshooting Procedures

Troubleshooting Table

This Troubleshooting Guide is for general aid only. Contact a Kohler Authorized Service Representative or a
qualified electrician to correct all electrical problems. For warranty service, contact your dealer or wholesale
distributor.
Symptoms
1. Green light in
"On/Off" control
switch flashes before
the bathing well is
full of water.
2. Product does not
start.
Kohler Co.
Probable Causes
A. Spout fills directly into
overflow channel.
B. One or both butterfly
valves do not work.
C. Control does not work.
A. No power to unit.
17
Recommended Action
A. Adjust/reinstall the spout
to fill directly into the
bathing well. Refer to the
installer/dealer.
B. Check the butterfly valve
wiring or replace the
butterfly valves. Refer to
the installer/dealer.
C. Check the wiring or
replace the control. Refer
to the installer/dealer.
A. Turn on the power to the
unit, or correct the source
of the power loss. Refer to
the installer/dealer.
1019731-2-C