Publicidad
Idiomas disponibles
Idiomas disponibles
Never use the product if you discover that it is
damaged in any way.
This products external flexible tube is non-
replaceable. Hence if it becomes damaged
you must dispose of the entire product.
This product does not contain any parts which
can be serviced by the user. The LEDs cannot
be replaced.
Only use the product with the supplied
mains adapter for the type (Model No.
JT-DC30V6W-H2-IP44 for HG01038A /
HG01038B / HG03931B,
JT-DC30V3.6W-H2-IP44 for HG03931A);
all warranty claims will otherwise expire.
Never open any of the electrical parts or insert
any kind of object into them.
Protect the mains cable from sharp edges,
mechanical loads and hot surfaces.
Do not install with sharp fasteners or nails.
Always unplug the mains adapter from the
socket before installation, dismantling or
cleaning.
Never touch the product's plug or the product
itself with wet hands.
The product must not be electrically connected
to another set of lights.
If the product is not in use for any length of
time (e.g. holidays), disconnect them from the
power supply.
If you have any questions about the product or
are unsure about any of its aspects, please seek
the advice of an electrical equipment specialist.
The product is only suited for use with the
included mains adapter (Model No.
JT-DC30V6W-H2-IP44 for
HG01038A / HG01038B / HG03931B,
JT-DC30V3.6W-H2-IP44 for HG03931A).
Please note that the mains adapter continues to
draw a small amount of power even if the product
is turned off as long as the mains adapter is
plugged into a power outlet. To switch the prod-
uct off completely, unplug the mains adapter
from the socket.
The LEDs are not replaceable.
If the LEDs fail at the end of their lifes, the entire
product must be replaced.
Use
Note: Remove all packaging materials from the
product.
Note: The LEDs are connected in series. If one LED
is defective, up to ten LEDs may not light up.
For HG03931A:
Put the ring
Insert the plug on end of the product into the
socket of the mains adapter
down the connecting nut
Insert the mains adapter
The light set
is switched on.
1
Pull the mains adapter
socket to switch off the light set
Timer function
To switch on the timer function, press the timer
button
after the product is connected to the
2
socket of power supply. The timer button
light up when the timer function is activated.
The product lights glow permanently for 6 hours
and will be followed by a subsequent pause of
18 hours. Afterwards, the product will light up
again at its designated turn on time for 6 hours
followed by a subsequent pause of 18 hours.
To switch off the timer function, press the timer
button
again and the light of the timer but-
2
ton
will be turned off.
2
Cleaning and care
CAUTION! DANGER OF ELECTRIC SHOCK!
First pull the mains adapter
CAUTION! DANGER OF ELECTRIC SHOCK!
For reasons of electrical safety the product must
never be cleaned with water or other liquids or
immersed in water.
over the top of the tree.
5
. Please screw
3
clockwise.
4
into the mains socket.
3
out of the mains
3
.
1
2
out of the mains socket.
3
GB/MT
will
19
Publicidad
