Replacing The Brushes - Polaris 9400 Sport 4WD El Manual Del Propietario

Figure 24. Wash Filter Canister
5.2

Replacing the Brushes

The cleaner is fitted with PVC brushes. There are ''wear''
indicators on the brushes (Figure 25). To maintain
cleaner performance at its best you need to replace the
brushes as soon as one of the wear indicators is reached
(even if the blade wear is not even). It is recommended
that you replace the brushes when the wear indicator is
reach or every two (2) years which ever comes first.
Figure 25. Wear indicators
1. Lift the cleaner to a vertical position so that the
handle is up (Figure 26).
1
Figure 26. Cleaner in Upright Position
7
2. Separate the edges of the brush and undo the
tabs (Figure 27). Remove the worn brushes.
2
Figure 27. Undo the Tabs of the Brush
3. To install a new brush, position the new brush
on the roller with the spikes facing downwards
(Figure 28).
3
Figure 28. install the New Brush
4. Thread each tab into the slot provided and
gently feed it through until the heel comes out
at the other side of the slot (Figure 29).
4
Figure 29. Pull Tabs Through Each Slot
5. Use a pair of scissors to cut the tabs 3/4 inch
from the heel so that they are no higher than the
spikes (Figure 30).
Page 15