Publicidad
Idiomas disponibles
Idiomas disponibles
Install Transformer
[]
Instati Transformer-Plug
into Transformer-Socket
and
tighten
securely,
(See Fig
1)
[]
lnstat! Transformer
to the Rear Cart Panel by using 4 Phillips
Head
Screws 3t16"x1/2"
and tighten using 4 Ftange Nuts 3116", (See Fig 2)
(You need to make 4 holes on your Rear Cart Panel first)
Pull the Transformer
Cord out through the gap between the Rear Cart
Panel and the floor,
[]
Plug Transformer
Cord into a properly
grounded
outlet
Note: In case of light bulb failure replace with 12 volt 10W bulb only to avoid
damaging
the electrical transformer
Phillips Head Screw
3It6 '_ x tt2"
Qty, 4
Part # $112G03081
Fiange Nut 3116"
Qty_ 4
Part #
$313G03051
Wire --,,
Transformer-socket .....
'"_t._!
Transformer-plug ---,
Fig
Install
ignitor
Battery
[]
Unscrew
Ignitor Cap from Control
Panel
[]
Place supplied AA battery into the Ignitor Slot with positive pole
facing you,
[]
Position the Cap and Spring over the AA battery and tighten onto
Control
Panel,
AA
Batter
Ignitor
Spring
Ignitor Slot
10
Publicidad
