Publicidad
Idiomas disponibles
Idiomas disponibles
Programming Guide S-100W - Ver. 1.0
Snapshot Mode Timeout
This parameter sets the amount of time the decoder remains in Snapshot Mode. The decoder
exits Snapshot Mode upon a trigger event, or when the Snapshot Mode Timeout elapses. To set
this timeout value, scan the bar code below followed by a bar code from Appendix D, Numeric
Bar Codes. The default value is 0 which represents 30 seconds; values increment by 30. For
example, 1 = 60 seconds, 2 = 90 seconds, etc.
Snapshot Mode Timeout
Snapshot Aiming Pattern
Select Enable Snapshot Aiming Pattern to project the aiming pattern when in Snapshot Mode,
or Disable Snapshot Aiming Pattern to turn the aiming pattern off.
Enable Snapshot Aiming Pattern
Disable Snapshot Aiming Pattern
185
Publicidad
Capítulos
