Publicidad
Idiomas disponibles
Idiomas disponibles
Programming Guide S-100W - Ver. 1.0
USB Interface
Introduction
This chapter describes how to set up the decoder with a USB host. The decoder connects
directly to a USB host, or a powered USB hub, and is powered by it. No additional power
supply is required.
Note: Most computer monitors allow scanning the bar codes directly on the screen. When
scanning from the screen, be sure to set the document magnification to a level where the bar
code can be seen clearly, and bars and/or spaces are not merging.
USB Parameter Defaults
Table below lists the defaults for USB host parameters. To change any option, scan the
appropriate barcode(s) provided in the Parameter Descriptions section.
Note: See Appendix A, Standard Default Parameters for all user preferences, hosts,
symbologies, and miscellaneous default parameters.
USB Host Default Table
216
Publicidad
Capítulos
