Maintenance - Dimplex CX-WIFI-A El Manual Del Propietario

Maintenance

Surface Cleaning
Use a cloth dampened with warm
water only to clean the housing
and glass display of the wall set-
ter. Do not use abrasive cleaners.
If the display needs to be cleaned,
putting the unit in the lock func-
tion will allow you to remove any
fingerprints or dirt without chang-
ing any settings.
Battery Replacement (Figure 6)
The Multi-zone programmable
CONNEX Controller contains a
TM
CR2032 (3V) battery. The inten-
tion of the battery is to allow
heater synchronization to be
carried out more conveniently.
Replacement of the battery will
only be required if additional syn-
chronization needs to take place
and a convenience receptacle is
not in the vicinity of the heater.
To replace the battery:
1. Remove stand from unit or
remove the unit from the wall.
2. Access the battery by remov-
ing the 6 screws that attach
the back cover to the unit.
3. Replace the battery.
! NOTE: Ensure that the bat-
tery is installed under the bottom
battery prongs.
4. Reassemble and remount the
remote control.
! NOTE: Multi-zone program-
mable CONNEX
retain all settings while battery is
removed and will revert to those
settings when power is restored.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area.
Figure 7
Controller will
TM
21