GE GXSH4OV Manual De Instalación página 18

Programming the Water Softener.
SET SALT LEVEL
1. Press the MODE/SET button until the arrow 4
points to SALT LEVEL.
Solt Level
Clock
Hordness
Rechorge
2. Determine level of salt in brine tank using yellow
indicator on side of brine well, inside brine tank
(see Figure 15).
3. Press UP _b, or DOWN _P" button to set the
SALT LEVELto correspond to level on yellow
indicator in brine tank.
Solt Level
Clock |
Hordness |
Rechorge [.
111_'2
-!.D
NOTE: Each press of a button changes the
level by increments of 0.5 up to 8.0. Lowering
the salt level below zero turns the SALT LEVEL
indicator OFF.
4. Press the MODE/SET button to accept. The
display shows the present time of day and
DAYS TO EMPTY.
[
iD.70 P. 1
3.]0
"7 "7 Days to Empty
CI
Figure 15
DAYS TO EMPTY
The words DAYSTO EMPTYand a number are
shown in the lower half of the display. This
information is shown in the normal run display.
This is to inform the user of the number of days
before the salt level in the brine tank reaches
Level 0. There will be salt left in the salt tank, but it
may not be sufficient to fully recharge the system.
Salt should be added at this time to avoid hard
water. The value is updated daily and whenever
the SALT LEVELvalue is changed.
7.1-1- A.
,:_.n,n _ _1
1l,_,,oo ,o
NOTE: For the first several weeks of operation, the
DAYSTO EMPTY may provide erratic operation.
For example, the blue indicator light may flash,
showing that more salt is required when the
actual salt level in the tank is well above the Level
0. In some cases, the DAYSTO EMPTYmay even
increase over a several week period.
It takes a couple of months for the water softener
to learn your water usage pattern. Once it does
this, it will accurately determine actual salt usage
pattern. During this first period, check salt level
when blue indicator light flashes. If the salt level
in the tank is at Level 1 or above, allow system to
run. Be sure to reset your salt level indicator each
time you add salt to the system.
START A RECHARGE
Press the RECHARGE button and hold for three
seconds, until "RECHARGE NOW" begins to flash
in the display, starting a recharge. This recharge
draws the sanitizing bleach into and through the
water softenen Any air remaining in the water
softener is purged to the drain. During this time
periodically check for leaks.
NOTE: As with all other water system
applications, leaks may occun Leaks may not be
immediately apparent. Recheck 24 hours after
first recharge cycle is complete.
18