Before you start.
BEFORE YOU START
The water softener
requires
a minimum
water flow of 3 gallons
per minute
at the inlet. Maximum
allowable
inlet water
pressure
is 125 psi. If daytime
pressure
is over 80 psi, nighttime
pressure
may
exceed the maximum.
Use a pressure
reducing
valve if necessary
(Adding o pressure
reducing
valve
may reduce the flow).
If your home
is equipped
with a back flow preventer,
on expansion
tank must
be installed
in accordance
with local codes and lows.
The water softener uses o direct plug-in external power supply (included). Be sure to use the included
power supply and plug it into o nominal 120V, 60 cycle household outlet that is in o dry location only,
grounded and properly protected by an over current device such as o circuit breaker or fuse.
Do not use this system to treat water that is microbiologicully unsafe or of unknown quality without
adequate disinfection upstream or downstream of the system.
TOOLS AND MATERIALS REQUIRED FOR INSTALLATION
Razor knife
Pliers
Screwdriver
Teflon tape
Two adjustable wrenches
Additional tools may be required if modification
to home plumbing is necessary.
INSPECT SHIPMENT
The ports required to assemble and install the water softener ore included with the unit. Thoroughly check
the water softener for possible shipping damage and ports loss. Also inspect and note any damage to the
shipping carton.
Remove and discord (or recycle) all packing materials. Toovoid loss of small ports, we suggest you keep the
small ports in the ports bug until you are ready to use them.
WARNING!
Discord oil unused ports ond pockoging material after installation. Small ports
remaining after the installation could be o choke hazard.
NOTE: Failure
to comply with these installation
instructions
will void the product
warranty,
and the
Ground Clamp
Kit
installer will be responsible for any service, re _air or damages caused thereby.
20 ft.
Clips
Drain Hose
Bypass Valve
Installation
Adaptors
Hose Clamps
Adaptor
Elbow
Grommet
O-rings
Drain Fitting
Drain Clip