General Warnings; Replacement Parts - Binks PX1304-5 Manual De Servicio

HIGH PRESSURE CAN CAUSE SERIOUS INJURY IF EQUIPMENT IS INSTALLED OR USED INCORRECTLY—
READ, UNDERSTAND, AND OBSERVE ALL WARNINGS AND INSTRUCTIONS IN THIS MANUAL.
INSTALL, OPERATE OR SERVICE THIS EQUIPMENT ONLY AFTER
ALL INSTRUCTIONS ARE CLEARLY UNDERSTOOD.
It is the responsibility of the employer to place this information into the hands of the operator.
WARNING
!
Hazards or unsafe practices which
could result in severe personal injury,
death or substantial property
damage.
AVOID STATIC SPARKING
1. Use Binks NO-WIRE conductive hose
in all airless spraying operations. Be
sure the gun and hose have
continuity.
2. Make sure the pump is grounded.
NEVER operate the unit when it is on
a non-grounded platform.
3. When flushing or cleaning with a
combustible solvent, always use an
open metallic container for receiving
the waste solvent. Ground the solvent
receptacle.
4. ALWAYS remove spray tip when
flushing the system. Operate the
pump at the lowest possible pressure.
Open
Metallic
Conductive Hose
Waste Solvent
To Airless Pump
Container,
Grounded
Bonding Wire,
Gun To Solvent Container
77-3040-R1.2 (10/2014)
WARNING
!
CAUTION
!
Hazards or unsafe practices which
could result in minor personal injury,
product or property damage.

GENERAL WARNINGS

1. NEVER leave a pressurized sprayer
unattended.
2. Periodically inspect all hoses for leaks
and/or abrasions and tighten all
connections before use. DO NOT
ATTEMPT TO REPAIR a defective
hose. REPLACE it with another
conductive hose.
3. ALWAYS relieve pressure in the system
by turning bypass valve to BYPASS or
triggering spray gun before disassembly
of any component parts.
CAUTION
!
Never store de-ionized, distilled,
reverse osmosis or any pure grade of
water in the pump. These fluids may
cause corrosion.
NOTE
BINKS is not responsible for misappli-
cation of pumps. Consult your BINKS
representative for application assis-
tance.
3 / 12
NOTE
Important installation, operation or
maintenance information.
NOTE
Be sure that all fluids, solvents and
fillers to be used are chemically and
physically compatible with wetted
parts in the pump. Consult your
BINKS representative for pump
materials of constructions and com-
patibility information. Consult the
fluid manufacture for information
regarding the fluids to be used.

REPLACEMENT PARTS

The pump is designed to use authorized
parts only. When using this pump with
parts that do not comply with the
minimum specifications and safety
devices of Binks, the user assumes all
risks and liabilities.
WARNING
!
EXCESSIVE AIR PRESSURE
Can cause personal injury, pump
damage or property damage. Do not
exceed maximum inlet air pressure
as stated on motor model plate.
EN