To Engage And Disengage The Roll Over Protection Structure (Rops); To Remove And Install The Door; To Remove And Install The Emergency Door - Husqvarna P 520DX Manual De Usuario

17. Attach the straps in the lifting eyes of the cabin.
18. Carefully lift the cabin in the straps with a lift.
19. Lift the cabin 10 cm above the product.
CAUTION:
is lifted above the bolts.
20. Carefully move the cabin forward.
21. Put the cabin in the cabin support. Refer to
of the cabin on page 57
WARNING:
installed when the cabin is removed.
Refer to
Roll Over Protection Structure (ROPS)
on page 20 .
22. Install in the opposite sequence.

To remove and install the door

1. Open the door 90 degrees.
2. Pull out the gas spring and loosen the ball joint.
3. Lift the door to remove it.
4. Install in the opposite sequence.

To remove and install the emergency door

1. Open the lock handle on the emergency door.
2. Remove the hinge pin.
3. Open the door 90 degrees.
4. Lift the emergency door to remove it.
5. Install in the opposite sequence.
20
Make sure that the cabin
Storage
ROPS must be
To engage and disengage the
To engage and disengage the Roll
Over Protection Structure (ROPS)
• Remove the 2 bolts that hold the ROPS and fold it
rearwards to disengage. Engage the ROPS in the
opposite sequence.
WARNING:
instructions for the ROPS and the seat
belt.
• Do not use the seat belt if the ROPS is disengaged.
• Always use the seat belt when the ROPS is
engaged.
• Make sure that the ROPS is correctly attached and
not damaged.
Obey the following
1593 - 002 - 22.12.2020