Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
KIA Sorento 2007-09
KIT FEATURES
• ISO DDIN radio provision
KIT COMPONENTS
• A) ISO DDIN trim panel • B) ISO DDIN brackets
A
B
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-7302
Antenna Adapter: • Not required
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
METRA. The World's best kits.
Installation instructions for part 95-7328
95-7328
metraonline.com
™
Table of Contents
Dash Disassembly ................................................. 2
Kit Assembly
– ISO DDIN radio provision ...................................... 3
CAUTION!
Metra recommends disconnecting the negative bat -
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con -
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
Publicidad
Manuales relacionados para Metra 95-7328
Resumen de contenidos para Metra 95-7328
- Página 1 KIT COMPONENTS • A) ISO DDIN trim panel • B) ISO DDIN brackets CAUTION! Metra recommends disconnecting the negative bat - tery terminal before beginning any installation, unless the vehicle manufacturer recommends against so. Please check with your local WIRING & ANTENNA CONNECTIONS (sold separately) Dealership for more information.
-
Página 2: Dash Disassembly
95-7328 Dash Disassembly 1. Unclip and remove the side trim panels. (Figure A) Note: Start at the bottom of the panels. 2. Remove (2) Phillips head screws securing the radio trim panel. Unplug and remove panel. (Figure B) 3. Remove (2) Phillips head screws... -
Página 3: Kit Assembly
(Figure B) 3. Locate the factory wiring harness and antenna plug in the dash and make all necessary connections to the radio. Metra recommends using the proper mating adapters from Metra and/or AXXESS. Re-connect (Figure B) (Figure A) the negative battery terminal and test the radio for proper operation. -
Página 4: Important
Installation instructions for part 95-7328 IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. -
Página 5: Características Del Kit
Instrucciones de instalación para la pieza 95-7328 Indice KIA Sorento 2007-09 95-7328 Desmontaje tablero ..........2 Ensamble del kit – Provisión de radio ISO DDIN ......... 3 CARACTERÍSTICAS DEL KIT • Provisión de radio ISO DDIN COMPONENTES DEL KIT • A) Panel de moldura de radio ISO DDIN • B) Soportes ISO DDIN ¡PRECAUCIÓN! -
Página 6: Desmontaje Tablero
95-7328 Desmontaje tablero 1. Desenganche y quite el paneles de moldura lateral. (Figura A) Nota: Comience en la parte inferior de los paneles. 2. Quite los (4) tornillos de cabeza Phillips que sujetan el panel de la moldura del radio. Desconecte y retire el panel. -
Página 7: Ensamble Del Kit
3. Localice el arnés de cableado de fábrica y el conector de la antena en el tablero y haga todas las conexiones necesarias al radio. Metra recomienda que use adaptadores adecuados de (Figura B) (Figura A) acoplamiento de Metra y/o de AXXESS. -
Página 8: Importante
Instrucciones de instalación para la pieza 95-7328 IMPORTANTE Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte técnico al 1-800-253-TECH. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese de que la instalación se haya realizado exactamente...