Assembly Of Segments - Hupfer SGR Manual Del Usuario

Transport, Installation, Initial Operation and Taking out of Service
Assembly
4.2.1

Assembly of segments

CAUTION
CAUTION
INFO
After the packaging material is removed, the conveyor system can be set up.
Conveyor systems with a length of more than 6 m will be delivered segments that have to be assembled.
Perform the following work steps when assembling the segments of the conveyor system:
§
During assembly, please make sure that the floors are level and even and the conveyor system is level.
§
The height of the conveyor system can be uniformly adjusted by means of the screw feet. Deviations are
adjusted with a spirit level in the cross direction. Normally, the height is 35.43'' (900 mm).
§
When assembling begin with the end of the belt. For this purpose, place the first segment on the marked
position.
§
Screw the segment under the next part of the belt. To do so, the first person holds the segment while the
second person pushes the next part of the belt onto the connector of the segment held by the first
person.
§
Assemble the segments in such a way that they are flush edge to edge. Ensure that the spacers are in
the correct position (between the belt and the connecting plate with the larger bore hole facing the belt).
Preload both plates with a hammer and a punch, then fasten all nuts with a maximum torque of 20 Nm.
§
Continue with the assembly as described above until the last segment.
§
Check again the inclination and align the conveyor system horizontally with the spirit level until it is level.
4330053_A7
Injury to persons and/or damage to property
There is a risk that parts of the conveyor system fall down during the
assembly. This can result in injuries to persons and damage to property.
Ask for help when assembling the segment and work at least in pair.
Damage to property
Do not place the segments onto the floor with the surface facing down, since
they can get scratched or damaged.
Use a suitable piece of material to place the segments.
Disposal of packing material
The packing consists of recyclable materials and can be disposed of
accordingly. The different materials should be separated and disposed of in
an environmentally friendly manner. The local agencies responsible for
disposal must be contacted regarding removal
Section 4
Page 21
Belt Conveyor System
SGR | SPV