Prelude 1992-1996; Prelude 1997-2001 - Metra 95-7801 Instrucciones De Instalación

Honda Prelude 1992-1996
1. Remove (2) screws from the top of the console trim bezel. Slide the front seats back
and remove (4) Phillips screws from each side of the bezel. Pull up on the console
trim bezel and remove. Using an angled screwdriver, remove (2) screws securing
the gear shifter bracket to the bezel. Remove (4) screws from the radio trim bezel,
remove the factory radio assembly and disconnect the wiring. (Figure A)
2. Cut and remove the mounting tabs from the bottom of the rear support tray
(Figure B, A). Cut and remove all mounting clips on the radio housing EXCEPT
clips "F" and "H" (Figure B, B). Cut and remove the slots on the bottom of the
ISO brackets (Figure B, C).
Note: The rear support tray will not be used in this application.
Continue to kit assembly
(Figure A)
Dash Disassembly
(A)
"F"
"H" "F"
"H"
(Figure B)
95-7801
Honda Prelude 1997-2001
1. Using a panel removal tool, unclip the radio trim bezel and remove (some force
may be required). Remove (4) Phillips screws securing the factory radio/bracket
housing assembly and disconnect the wiring. Remove (4) Phillips screws
securing the factory radio to the bracket housing and remove. (Figure A)
2. Cut and remove all mounting clips on the radio housing EXCEPT clips "A" and
"G". (Figure B)
Continue to kit assembly
(B)
(Figure A)
13
"A"
"G"
"G"
(Figure B)
"A"