Metra 95-7801 Instrucciones De Instalación página 15

ISO DDIN radio provision
1. Cut and remove the dividing rib from the radio opening.
2. Align the holes in the ISO brackets with the holes in the radio, and then secure it with the
screws included with the radio. (Figure A)
3. Slide the rear support tray under the radio, position the radio housing over the radio, and then
secure the assembly to the ISO brackets with (4) #6 x 1/4" Phillips screws supplied. (Figure A)
4. Secure the rear support tray with (2) #6 x 1/4" Phillips screws supplied. (Figure A)
5. Locate the factory wiring harness and antenna connector in the dash, and complete all
necessary connections to the radio. Metra recommends using the proper mating adapter from
Metra and/or AXXESS. Re-connect the negative battery terminal and test the radio for proper
operation.
6. (a) Honda Accord 1994-1997, Acura CL 1997-1999:
1. Mount the completed assembly into the radio cavity with the (2) screws previously
removed in dash disassembly.
2. Reassemble the dash in reverse order of disassembly.
(b) Honda Accord 1998-2002, Honda Odyssey (without NAV) 1999-2004:
1. Mount the completed assembly into the radio cavity with the (4) screws previously
removed in dash disassembly.
2. Reassemble the dash in reverse order of disassembly.
(c) For all other applications:
1. Cut and remove all the mounting tabs on the ISO brackets.
2. Cut and remove the mounting tabs from the bottom of the rear support tray. (Figure B).
3. Reassemble the dash in reverse order of disassembly.
4. Snap the completed assembly into the radio cavity.
95-7801
Kit Assembly
3b
(Figure A)
(Figure B)
15
(A)