Tape Recording; Operation - Aiwa CSD-MD50 Manual De Instrucciones

OPERATION
F oDL—
000
I
3
000
000
000
0
L
2
@
<,
[T
+H II
Set the tape to the point where recording will start,
Use Type 1 (normal) tapes only for recording.
Load the tape to be recorded on into the deck.
Load the tape with the side to be recorded on first facing
toward you and the exposed side facing downward.
Press the FUNCTION button on the remote
control repeatedly until tape is selected.
Press the MODE button on the remote control
repeatedly to select the reverse mode.
To record on one side only, select =.
To record on both sides, select 1) or (Z).
When recording from the rear of the tape, the tape stops at
the end of recording of the rear side, even if the reverse mode
is set to 1) or (1).
Prepare the source to be recorded.
To record from a radio broadcast,
press the TUNER/BAND
button and tune in to a station.
To record from a
CD or MD,
first press the CD P or MD F
button and load the disc, then press the <+ or * button
or turn the MULTI JOG dial to select the track to be recorded
first.
Press the TAPE REC button to start recording.
TAPE~ appears on the display.
When the selected source is CD or MD, playback and
recording start simultaneously.
To stop recording,
press the button. When recording from a
CD or an MD, press the button again to stop playback.
To pause recording, press
me II button. (Applicable when the
source is the radio.) To resume recording, press again.
m
If squealing or beating sounds occur when recording an AM
broadcast, press the MODE button repeatedly and select one of
the two modes, BEAT 1 or BEAT 2, which eliminates the noise
better.
RECORDING A WHOLE CD OR MD ONTO
A TAPE
Use the CD/MD~TAPE button to record all the tracks of a CD
or MD onto a tape from the beginning.
If the tape reaches its end of the front side while a track is being
played, recording of this track starts from the beginning on the
opposite side of the tape,
Prepare a tape having a length longer than the total playing time
of
1
2
3
4
the CD or MD to be recorded.
Load the tape to be recorded on into the deck.
Press the TAPE + button to select the side to
be recorded, then set the tape to the position to
start recording.
When recording a CD :
Load the disc and press the FUNCTION button
on the remote control to select CD.
When recording an MD:
Load the disc and press the FUNCTION button
on the remote control to select MD.
Press the CIWMD>TAPE button.
Playback and recording starts simultaneously.
If recording was started from the front side of the tape, and
when recording on the front side ends, recording on the rear
side starts.
If recording was started from the rear side, and when recording
on the rear side ends, recording stops.
To stop recording
Press the button.
To stop playback, press the button again.
To erase a recording
1 Insert the tape
to be erased into the deck.
2 Press the TAPE +E button to select the side to be erased,
then set the tape to the point where the erasure is to be
started.
3 Press the TAPE REC button to start the erasure.
ENGLISH ~
7