Grouping Connection - Carrier HDB Manual De Instalación

HDB controller

Grouping connection

Fit the communication board into the special connector which can
be reached only after cover 1 and cover 2 have been removed.
Proceed as follows:
• Remove cover 1
• Remove cover 2 (screw + clips)
Connect the units in daisy chain configuration (white and blue cables in parallel) for grouping. Refer to the figure below.
B
BLUE
B
GREY
C
WHITE
A
BLACK
GND
RED
12V
1

1
6
Grouping configuration of several units
B
C
A
GND
12V
A
• Fit the board onto connector J8
For the Cassette unit, remove the metal cover as previously
described, and remove the board from its seat.
Install the communication board.
For more information refer to the manual provided with the grouping
kit.
BLUE

GREY
WHITE
BLACK
RED

B
BLUE
GREY
WHITE
BLACK
RED
A
2
 First indoor unit
 Second indoor unit
 Third indoor unit
E N G L I S H

B
C
A
GND
12V
 Main board
 Communication board
 5-wire wiring
 Auxiliary terminal block
B
BLUE
B
GREY
C
WHITE
A
BLACK
GND
RED
12V
A
3
Comunication board
B To the other terminal block
GB - 5