Evolution EVOSAW 355 Manual De Instrucciones página 17

www.evolutionpowertools.com
(5.9)
CUTTING HEAD TRAVEL
Cutting Head Downward Travel Adjustment
To prevent the blade from contacting any part of the
machine's metal base the downward travel of the
cutting head can be adjusted.
Lower the cutting head and check for any blade contact with
the machine's base.
If the downward travel of the cutting head needs to
be adjusted:
• Loosen the locknut on the downward travel stop screw.
(Fig. 7a)
• Turn the adjusting screw (Fig. 7b) out (counter-clockwise) to
decrease the downwards travel of the cutting head.
• Turn the adjusting screw in (clockwise) to increase the
downwards travel of the cutting head.
• Tighten the adjustment screw locknut when satisfactory
downward travel of the cutting head is achieved.
(5.10)
CUTTING ANGLE ADJUSTMENT
Note: The rear vise jaw can be turned through 45
The rear vise jaw is factory set at 0
the blade cuts squarely across material positioned in the vise.
For angled cuts, the rear vise jaw can be swung through (up to)
45 , with a protractor scale being included on the vise jaw for
0
ease and accuracy of setting. (>5.10)
To angle the rear vise jaw:
• Loosen the M10 socket headed screw and the lever handled
locking screw. (Fig. 8)
• Turn the rear vise jaw to the required angle.
• Tighten the socket headed screw securely using the supplied
hex key and tighten the lever handled locking screw.
Note: The lever handle locking screw has a spring loaded
repositionable lever. Repositioning of the lever may be
necessary to ensure that the locking screw can be tightened
sufficiently when the rear vise jaw is angled. To reposition
the lever on the screw, pull the lever upwards and rotate the
lever to a convenient position (one that allows the screw to be
tightened) release the lever and tighten the screw. The front
vise jaw will automatically compensate for any set angle of the
rear jaw, or to accommodate irregular shaped workpieces.
.
0
(at 90 to the blade) so that
0 0
17
B
A
Fig. 7
Fig. 8
EN
ES
FR