Removing And Storing Latch Connectors - GB IDAN Manual Del Usario

removInG and StorInG latCh ConneCtorS

to Remove from storage:
to install the Base using latCh, the
connectors must be removed from their storage
compartments.
1
to access the latCh Connector storage
compartments, squeeze the level adjustment
handle to fully extend the leveling foot.
2
Remove each connector by pushing the red
button while pulling out.
3
lengthen the strap between the connectors
using the latCh strap adjuster located next to
the connector on the right-hand side. push down
on the adjuster button while lengthening strap.
32
1
2
3