GB IDAN Manual Del Usario página 39

fully open Belt tensioning plate by turning the
orange locking lever to the
6
and lifting up on the plate.
once open, the Belt tensioning plate will remain
open on its own. the locking lever should be in
the open position with the plate open.
attach both latch connectors to the lower
latch anchors. each should make an audible
7
click when attached. make sure they are
attached by pulling firmly on the connectors.
push Base against vehicle seat back. tension
the latch strap by pulling on the latch strap
8
tensioning loop to take the slack out of the
latch strap, just enough to make it snug. tuck
the loose end of the strap under the base so it
Will not inteRfeRe with the closing of the Belt
tensioning plate or the connection of the infant
carrier to the Base.
at this point, the latch strap should only be
snug as the Belt tensioning plate will tighten the
system fully.
open position
7
CLICK!
6
CLICK!
8
39